1. 기존 PLANT 내의 제어실에 새로운 CONTROL SYSTEM 을 설치하고 기존 CONTROL SYSTEM 과의 DATA COMMUNICATION을 하려고 한다. 이때 고려해야할 사항을 설명하시오. 또한, OSI (Open System Interconnection) 7 Layer 에 대해 설명하고 TCP/IP 4계층과 비교 및 적용되는 Protocol의 예를 드시오.
① 이기종간의 제어시스템간의 데이타
2.3 C-V graph
The measured MOS capacitance (called gate capacitance) varies with the applied gate voltage.
① Measurement of C-V characteristics
-Apply any DC bias, and superimpose a small (15 mV) ac signal
-Generally measured at 1 MHz (high frequency) or at variable frequencies between 1KHz to 1 MHz
-The dc bias VG is slowly varied to get quasi-continuous C-V characteristics
② C-V chara
4. Equipment
4.1 RCA cleaning
RCA cleaning is a series of rinsing procedure prior to experiment with Si wafer. The purpose of the RCA clean is to remove organic contaminants (such as dust particles, grease or silica gel) from the wafer surface. There are three steps to be performed. The first step is to remove organic contaminant from surface of wafer. Second step is to remove any oxide layer
Abstract- This paper presents an X-band voltagecontrolled
hairpin resonator oscillator using GaAs
MESFET varactor. To get wide tuning range, the
hairpin resonator is combined with the MESFET
varactor. It is incorporated into the series feedback
oscillator. The measurement of the oscillator
showed the frequency tuning range of 11.15 MHz
with the output power flatness less than 0.10 dB at
t
Calculation will be
10*60 parallel arrays 600mA/1A
7*3.4 series arrays 23.8V/25.4V
★LED quantity can be adjusted when it is needed
Apply the dimming system at the circuit
Reflector setting(Using mirrors and so on)
Outlet designing and scaling
Luminance examination(whether it is following industry standards)
4. Bradford Assay
- Bradford Reagent는 95% ethanol, 88% phosphoric acid, Brilliant Blue G로 이루어져 있다. Ethanol은 유기용매이기 때문에 coomassie blue를 Bradford reagent 내에 잘 용해 시키고, phosphoric acid는 reagent가 산성 조건을 충족시키게 한다. 산성 조건 하에서 Coomassie blue는 doubly-protonated red form이 되기 때문에 6개의 phenyl grou
1. 태양광 발전의 특징
태양광 산업은 무한정 무공해의 자원을 활용하여 전기를 생성하는 신재생 에너지원으로 1990년대 이후 기후변화협약에 따른 환경문제가 범세계적으로 심각하게 대두됨에 따른 삶의 질을 향상시킬 수 있는 환경 친화적 에너지 기술로서, 태양광을 받아 전기를 발생하는 태양전
1. 실험 제목
Cantilever Beam을 이용한 Energy Harvesting Modeling
2. 이론
1) Energy Harvesting
거대 용량의 전기를 발생시키기 위한 전통적인 수력 발전, 화력 발전, 풍력 발전, 조력 발전, 태양광/태양열 발전 기술보다도 음파, 초음파, 또는 주위에서 쉽게 발생할 수 있는 소음, 떨림, 구부러짐, 수축, 신장과
○ PECVD
∙ What is PECVD?
⇒ Radio frequency(RF) is used to induce plasma in the deposition gas.
⇒ This results in a higher deposition rate at relatively low temperatures.
⇒ With the plasma enhanced CVD process is the deposition at temperature around 300℃ allows.
⇒ The temperature will be through encouragement of a plasma with high frequency electric fields triggered.
1.서론
최근 반도체 직접회로 제조기술을 응용한 미소기계부품의 제작이 가능하게 됨에 따라 마이크로미터, 나노미터 크기의 미소부품과 이들의 작동에 필요한 집적회로를 하나의 칩으로 일체화 시킨 미세전기기계시스템(MEMS: MicroElectroMechanical Systems)이 등장하였으며, 급격한 발전을 이룩하였다. 또